Zanussi ZFC 50/17 AL Manual de instrucciones - Página 13
Navegue en línea o descargue pdf Manual de instrucciones para Frigorífico Zanussi ZFC 50/17 AL. Zanussi ZFC 50/17 AL 16 páginas. Zanussi owners manual compact refrigerator freezer zfd 50/17 r, zfd 50/17 ral
También para Zanussi ZFC 50/17 AL: Manual de instrucciones (19 páginas)
Imprimir página
MAINTENANCE AND CLEANING
Before any maintenance or cleaning work is carried
out, DISCONNECT the appliance from the
ELECTRICITY supply.
Internal cleaning
Clean the inside and accessories with warm water
and bicarbonate of soda (5ml to 0.5 litre of water).
Rinse and dry thoroughly.
NEVER USE DETERGENTS, ABRASIVE
POWDERS, HIGHLY PERFUMED CLEANING
PRODUCTS OR WAX POLISHES, TO CLEAN
THE INTERIOR AS THESE WILL DAMAGE
THE SURFACE AND LEAVE A STRONG
SMELL.
Clean the drain hole of the water trough at regular
intervals and make sure that the drain hole is never
obstructed, so that the defrost water may flow
freely.
External cleaning
Wash the outer cabinet with warm soapy water. Do
NOT use abrasive products.
Once or twice a year dust the condenser (black grill)
and the compressor at the back of the appliance,
with a brush or vacuum cleaner, see Fig. 9.
CONDENSER
DEFROST
TRAY
COMPRESSOR
D280
You MUST ensure that the appliance is switched
OFF. An accumulation of dust will affect the
performance of the appliance and cause excessive
electricity consumption.
Fig. 9
When the appliance is not in use
When the appliance is not in use for long periods,
disconnect from the electricity supply, empty all
foods and clean the appliance, leaving the doors ajar
to prevent unpleasant smells.
Changing the light bulb
Should the interior light fail to work, first switch off
the appliance and disconnect from the electricity
supply, then replace the bulb as follows;
D411
unscrew the light cover and then pull it outward by
pressing as shown in the Fig. 10. Unscrew the bulb
and replace it with a new 15 watt bulb (available
from your nearest Zanussi Service Force Centre).
Replace the light cover by sliding it into its original
position and replacing the screw.
Fig. 10
13