Zanussi ZI 418/9 Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Frigorífico Zanussi ZI 418/9. Zanussi ZI 418/9 12 páginas.

Imprimir página

INSTALLATION

If this appliance featuring magnetic door seals is to

replace an older appliance having a spring lock (latch) on

the door or lid, be sure to make that spring lock

unusable before you discard the old appliance.

This will prevent it from becoming a death-trap for a

child.

Positioning

The appliance should be installed well away from

sources of heat such as radiators, boilers, direct

sunlight etc.; best performance is obtained with

ambient temperature between +16 C and +32 C.

For building-in and door reversibility, if necessary,

refer to the relevant instructions in the following

pages.

Electrical connection

Before plugging in, ensure that the voltage and

frequency shown on the serial number plate

correspond to your domestic power supply. Voltage

can vary by 6% of the rated voltage.

For operation with different voltages, a suitably

sized auto-transformer must be used.

Important

It is essential that the appliance be connected to an

efﬁcient earth tap. For this purpose the supply

cable plug incorporates a special earth contact. If

the sockets of your domestic wiring system are not

earthed, have the appliance connected to a separate

earth wire by a qualiﬁed electrician in accordance

with existing safety regulations.

The manufacturer declines to accept any liability should

this safety rule not be observed.

This appliance complies with E.E.C. directive

No. 87/308 of 2.6.87 relative to radio interference

suppression.

This appliance complies with the following

E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage Directive) and

subsequent modiﬁcations;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modiﬁcations.

Cleaning the interior

Before using the appliance for the ﬁrst time, wash

the interior and all internal accessories with

lukewarm water and some neutral soap so as to

remove the typical smell of a brand-new product,

then dry thoroughly. Do not use detergents which

will leave an odour or abrasive powders on the

interior, as these will damage the ﬁnish.