Zanussi ZI 9230/2T Manual de instrucciones - Página 9
Navegue en línea o descargue pdf Manual de instrucciones para Frigorífico Zanussi ZI 9230/2T. Zanussi ZI 9230/2T 12 páginas.
Imprimir página
INSTALLATION
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
For building into kitchen units follow the special
ÒBuilding-in instructionsÓ given.
ATTENTION!
It must be possible to disconnect the appliance from
the mains power supply; the plug must therefore be
easily accessible after installation.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply. Voltage
can vary by ±6% of the rated voltage.
Changing the opening direction of
the doors
Before buiding-in the appliance (if necessary),
change the opening direction of the doors. To do
this, proceed as follows:
1. Remove the cover of the top hinge.
2. Unscrew the top hinge.
3. Remove the hole plugs on the opposite side; the
holes that are not used must be masked.
4. Disassemble the bottom grille.
5. Unscrew the side hole plug and refit it on the
other side.
6. Disassemble the bottom hinge.
7. Remove the two doors.
20
For operation with different voltages, a suitably sized
auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the following
E.E.C. Directives:
- 87/308 EEC of 2/6/87 relative to radio interference
suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
D120
D745