Zanussi ZR 54/3 Instrucciones de uso y cuidado - Página 8
Navegue en línea o descargue pdf Instrucciones de uso y cuidado para Frigorífico Zanussi ZR 54/3. Zanussi ZR 54/3 12 páginas. Refrigerator
También para Zanussi ZR 54/3: Manual de instrucciones (12 páginas), Manual de instrucciones (12 páginas)
Imprimir página
Door reversal
directions (Rg 3 «
Before carrying out the operations
described below, pull out the mains plug
from the wall socket.
To carry out this reversal go through the
following steps:
a)
Remove bottom hinge 6;
b)
Remove door 5;
c)
Unscrew pin 3 from the top hinge 2 and
refit it on the opposite side;
d)
Unscrew part 7 and refit it on the
opposite side;
e) Refit the door and the bottom hinge
(into the holes already provided);
0 Remove handle 4 and refit it on the
opposite side (the fixing holes are
already provided).
Aligning the moulded plastic
worktop (Fig. 3)
The appliance comes with the worktop
aligned with the door.
To change the alignment, proceed as
follows:
remove the two screws A securing the
plate (1) at the rear, shift it forward to the
required position and then refit the two
fixing screws.
Aligning the laminated plastic
worktop (Fig. 4)
The 5.pphance comes with the worktop
aligned with the door.
To change the alignment, proceed as
follows;
a)
Remove the two screws A;
b)
Remove wall spacer 9 (which is push-
fitted) by pulling it out at both ends;
c)
Slide out panel 1;
d)
Remove the screws fixing frame 8 to
the cabinet and, after selecting the new
position, refit the frame and screw
down the previously removed screws;
e) Refit panel 1 and wall spacer 9;
fi Refit the two fixing screws A
Fig. 3
Fig'. 1
6