Clarke ZX-R Pro Series Manual de instrucciones de uso y mantenimiento - Página 6

Navegue en línea o descargue pdf Manual de instrucciones de uso y mantenimiento para Herramienta eléctrica Clarke ZX-R Pro Series. Clarke ZX-R Pro Series 17 páginas. 20v cordless multi function tool
También para Clarke ZX-R Pro Series: Manual de funcionamiento, mantenimiento e instrucciones (8 páginas), Manual de instrucciones de uso y mantenimiento (9 páginas), Manual de instrucciones de uso y mantenimiento (17 páginas), Manual de instrucciones de uso y mantenimiento (13 páginas), Manual de instrucciones de uso y mantenimiento (17 páginas)

SYMBOLS & PICTOGRAPHS

KICKBACK

Kickback is a sudden reaction to a pinched or misaligned saw blade which causes the

saw to lift up and out of the workpiece.

When the blade is pinched or bound tightly by the kerf closing down, the blade stalls

and the motor reaction moves the unit back quickly towards the operator.

If the blade becomes twisted or misaligned in the cut, the teeth at the back edge of the

blade can dig into the top of the workpiece causing the blade to climb out of the kerf

and jump back towards the operator. Kickback is the result of misuse or incorrect

operating procedures and can be prevented by taking the following precautions:

a. Hold the saw tightly and position your arms to resist kickback forces. Position your

body to one side of the blade.

b. If the blade starts to bind, or when interrupting a cut, release the trigger and hold

the saw still in the material until the blade comes to a full stop. Do not attempt to

remove the saw from the work or pull the saw backward while the blade is

moving or kickback can occur. Investigate and take corrective actions to

eliminate the cause of blade binding.

c. When restarting a saw in the workpiece, centre the saw blade in the kerf and

make sure that saw teeth do not touch the material. If the blade is binding, it

can kickback from the workpiece as the saw is restarted.

d. Support large panels to minimise the risk of blade pinching and kickback. Large

panels tend to sag under their own weight. Supports must be put below the

panel on both sides, near the line of cut and near the edge of the panel.

e. Bevel adjusting locking screws must be tight and secure before making a cut. If

blade adjustment shifts while cutting, it may cause binding and kickback.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

Weee Symbol

Read instruction manual before use

Laser Radiation, Class 2 Laser: Do not stare

into the beam

CE Mark