Zanussi ZOD35712BK Manual del usuario - Página 19
Navegue en línea o descargue pdf Manual del usuario para Horno Zanussi ZOD35712BK. Zanussi ZOD35712BK 24 páginas.
Imprimir página
4. Hold the door with one hand on each side
and pull it away from the appliance at an
upwards angle.
5. Put the door with the outer side down on a
soft cloth on a stable surface. This is to
prevent scratches.
6. Hold the door trim (B) on the top edge of
the door at the two sides and push inwards
to release the clip seal.
2
B
CAUTION!
Rough handling of the glass,
especially around the edges of the
front panel, can cause the glass to
break.
7. Pull the door trim to the front to remove it.
8. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide.
Troubleshooting
WARNING!
Refer to Safety chapters.
What to do if...
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
www.zanussi.com
1
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
9. Clean the glass panel with water and soap.
Dry the glass panel carefully.
When the cleaning is completed, install the
glass panels and the door. Do the above steps
in the opposite sequence. Install the smaller
panel first, then the larger.
Replacing the lamp
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp.
The lamp and the lamp glass cover
can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
The lamp glass cover is at the back
of the cavity.
1. Turn the lamp glass cover counterclockwise
to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a suitable 300
°C heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Remedy
19