Zanussi ZOP37909 Manual del usuario - Página 20
Navegue en línea o descargue pdf Manual del usuario para Horno Zanussi ZOP37909. Zanussi ZOP37909 28 páginas.
También para Zanussi ZOP37909: Manual del usuario (28 páginas)
Imprimir página
and the bars of the heat indicator until
the door unlocks.
To stop Pyrolysis before it is completed,
turn the knob for the oven functions to the
off position.
6. When Pyrolysis is completed, the display
shows the time of day. The oven door stays
locked.
7. When the appliance is cool again, an
acoustic signal sounds and the door
unlocks.
Cleaning reminder
To remind you that the Pyrolysis is necessary,
PYR flashes in the display for 10 seconds after
each activation and deactivation of the
appliance.
The cleaning reminder goes out:
• after the end of the Pyrolysis
function.
• if you press
same time while PYR flashes in
the display.
Cleaning the oven door
The oven door has three glass panels.You can
remove the oven door and the internal glass
panels to clean them.
The oven door can close if you try to
remove the glass panels before you
remove the oven door.
CAUTION!
Do not use the appliance without the
glass panels.
1
Open the door fully
1
and hold the two
door hinges.
20
and
at the
2
Lift and turn the
2
levers on the two
hinges.
3
Close the oven door
3
halfway to the first
opening position.
Then pull forward and
remove the door from
its seat.
5
Release the locking
5
system to remove the
glass panels.
7
2
1
First lift carefully and
7
then remove the
glass panels one by
one. Start from the
top panel.
Clean the glass panels with water and soap.
Dry the glass panels carefully.
When the cleaning is completed, install the
glass panels and the oven door. Do the above
steps in the opposite sequence.
Make sure that you put the glass panels (A and
B) back in the correct sequence. The middle
panel (B) has a decorative frame. The screen-
printing zone must face the inner side of the
door. Make sure that after the installation the
surface of the glass panel frame (B) on the
4
Put the door on a soft
4
cloth on a stable
surface.
6
90°
Turn the two
6
fasteners by 90° and
remove them from
their seats.
www.zanussi.com