Zanussi ZOP38903XD Manual del usuario - Página 20

Navegue en línea o descargue pdf Manual del usuario para Horno Zanussi ZOP38903XD. Zanussi ZOP38903XD 24 páginas. Product manaul
También para Zanussi ZOP38903XD: Manual del usuario (28 páginas)

Imprimir página

1 2

Make sure that you put the glass panels (1, 2

and 3) back in the correct sequence. The mid-

dle panel (2) has a decorative frame. The

screen-printing zone must face the inner side

of the door. Make sure that after the installation

the surface of the glass panel frame (2) on the

screen-printing zones is not rough when you

touch it.

What to do if...

Warning! Refer to the Safety chapters.

Problem

The oven does not heat up.

The oven lamp does not oper-

ate.

The oven does not heat up.

The fan does not operate. The

display shows

Possible cause

The appliance is deactivated.

The clock is not set.

The necessary settings are not

set.

The automatic switch-off is on.

The Child Lock is on.

The fuse in the fuse box is re-

leased.

The oven lamp is defective.

The demo mode is activated.

Make sure that you install the top panel in the

seats correctly.

Activate the appliance.

Set the clock.

Make sure that the settings are cor-

rect.

Refer to "Automatic switch-off".

Refer to "Deactivating the Child Lock".

Do a check of the fuse. If the fuse is

released more than one time, contact

a qualified electrician.

Replace the oven lamp.

1. Deactivate the appliance.

2. Press and hold the button

approximately two seconds. An

acoustic signal sounds.

3. Press and hold the buttons

and

acoustic signal sounds again and

the indicator goes out.

Remedy

for

at the same time until the