Zanussi FJ 1296 Manual de instrucciones - Página 5

Navegue en línea o descargue pdf Manual de instrucciones para Lavadora Zanussi FJ 1296. Zanussi FJ 1296 19 páginas. Zanussi washing machine instruction booklet fj 1296

Imprimir página

1. Control Panel

Water drainage

If you intend the drain hose from the machine to empty

into a sink, make sure that the sink is empty and that the

plug hole is not blocked.

If the machine is permanently plumbed in, hook the end

of the hose into a standpipe installed for the purpose.

The standpipe must have an internal diameter of at least

40 mm (1

") in order that there is an air gap between

the drain hose and the standpipe. Make sure, that it is

designed in such a way, that the end of the drain hose

cannot be covered with water.

3 pin

P0376

Important

Before connecting up the machine to new pipework or to

pipework that has not been used for some time, run off a

reasonable amount of water to flush out any debris that

may have collected in the pipes.

Whether discharging into a sink or a standpipe check

that the end of the drain hose is neither too high nor too

low. The top of the curve in the hose's end should be no

more than 90 cm (35.4"), and no less than 60cm (23.6")

above floor level.

Levelling

P0850

prevents vibration, noise and displacement of the ma-

chine during operation.

Some vibration is inevitable, especially if mounted on a

wooden floor.

Sprung wooden floors are particularly susceptible to

vibration. For advice, consult a builder. If possible,

always place the machine on a solid floor.

Special conditions

If the floor is carpeted with a deep-pile carpet or covered

with crumbly or soft material, insert a rigid support base

under the feet to prevent noise, vibration or displace-

ment. The base should protrude a few centimetres

beyond the edges of the machine.

Joining piece

40 mm

inside dia min

600 mm min

900 mm max

Level the washing ma-

chine by raising or low-

ering the feet. The feet

may be tight to adjust as

they incorporate a self

locking nut, but the machi-

ne MUST be level.

Any necessary adjustment

can be made with a span-

ner. Accurate levelling

Warning

The machine should NOT be placed on deep pile car-

peting.

Note

Please ensure that when the appliance is installed it is

easily accessible for the engineer in the event of a break-

down.

All plumbing and electrical work required to install this

appliance must be carried out by competent persons or

qualified plumbers or electricians.

In the interest of the environment

Washing machines and dishwashers should be connec-

ted to the FOUL drainage system, the water will then be

taken to a sewage works for treatment before being

discharged safely into a river.

It is essential that these appliances are not connected to

the surface water drainage system as this water is

discharged directly into a river or stream and may cause

pollution.

If you require any further advice please contact your

local authority drainage department.

SHOWER

BATH

WASHING

MACHINE

RAINWATER

'RUN-OFF'

SURFACE WATER

DRAINS & SEWERS

UNTREATED

DISCHARGE

RIVER

P0987

SINK

TOILET

BIDET

DISHWASHER

FOUL DRAIN

FOUL SEWERS

SEWAGE

TREATMENT

WORKS

TREATED

DISCHARGE

RIVER