Zanussi FJ 1354 S Manual de instrucciones - Página 10
Navegue en línea o descargue pdf Manual de instrucciones para Lavadora Zanussi FJ 1354 S. Zanussi FJ 1354 S 26 páginas. Zanussi instruction washing machine fj 1054 w fj 1254 w fj 1354 s fj 1454 w
Imprimir página
7. Select the spin speed or the
RINSE HOLD option
Press the SPIN SPEED button repeatedly, in order to
select the desired spin speed or the RINSE HOLD
option. The relevant light will light up.
If you select the RINSE HOLD option, the machine will
stop at the end of the programme with the water still in
the tub.
8. Select the desired options
If your laundry is very dirty, it may be advisable to
select the PREWASH option.
If your laundry is lightly or normally soiled and it is
necessary to prolong the washing time, select the
AA40° option.
If your laundry is only slightly soiled, select the QUICK
option. The relevant light illuminates.
9. Start the programme
Press the START/PAUSE button. The relevant light will
stop flashing, the DOOR LOCKED light will light up,
and only the light relevant to the phase that is in
progress will remain lit.
10. How to change a programme
during its cycle
Before you make any change, you must pause the
washing machine by pressing the START/PAUSE
button.
It is possible to change any phase before the programme
carries it out.
Changing the type of fabric or temperature is possible,
obviously, only during the washing phase. When you
make a change in these two parameters, the washing
machine will resume the cycle from the beginning.
If it is necessary to drain the water in order to change
the programme in progress, proceed as follows:
• PAUSE the machine by pressing the START/PAUSE
button;
• press the SKIP/RESET button repeatedly, until only
the DRAIN light remains lit;
• press the START/PAUSE button again.
When the water has been drained, you may now select a
new programme and press the START/PAUSE button to
start it.
11. How to cancel a programme
during its cycle
To cancel a programme that is being carried out, first
pause the washing machine by pressing the
START/PAUSE button, then press the SKIP/RESET
button repeatedly, until the phase indicator lights go out.
12. How to open the door during
the cycle of a programme
You can open the door, after having set the washing
machine to PAUSE, provided the following conditions
exist:
• the washing machine is not in the heating phase
beyond 55°C;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, when you pause the
washing machine, the DOOR LOCKED light goes out
and the door can be opened.
Should it not be possible to open the door, and should it
be absolutely necessary to do so, switch the machine off
by pressing the ON/OFF button.
After approximately 3 minutes, you can open the door.
10