Zanussi FJ1224/A Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Lavadora Zanussi FJ1224/A. Zanussi FJ1224/A 37 páginas. Zanussi washing machine instruction manual
También para Zanussi FJ1224/A: Manual de instrucciones (36 páginas)

Zanussi FJ1224/A Manual de instrucciones
If you intend the drain hose
from the machine to empty
into a sink, make sure that the
sink is empty and that the plug
hole is not blocked.
If
the
| machine
is
permanently plumbed in, hook
the end of the drain hose into
a standpipe installed for the
purpose.
The standpipe must have an
internal diameter of at least
30 mm (1 1/2 in), in order that
there is an air gap between the
drain
hose
and
standpipe.
Make sure, that it is designed
in such a way, that the end of
the
drain
hose
cannot
be
covered with water.
Important: Before connecting
up
the
machine
to
new
pipework or to pipework that
has not been used for some
time,
run
off
a reasonable
amount of water to flush out
any
debris
that
may
have
collected in the pipes.
Whether discharging into a
sink or a standpipe
check
that the end of the drain hose
is neither too high nor too
low. The top of the curve in
the hose's end should be no
more than 90 cm (35.4") and
no less than 60 cm (23.6")
above floor level.
INSTALLATION INSTRUCTIONS
ELECTRICAL CONNECTION
WARNING:
THIS APPLIANCE
MUST BE EARTHED
The manufacturer declines any
liability
should
this safety
measure nof be observed.
If the plug that is fitted to
your appliance is not suitable
for your socket outlet, it must
be cut off and the appropri-
ate plug fitted.
The cut off plug should be
disposed of to prevent the
hazard of electric shocks in
case it should be plugged into
a 13 Amp socket in another
part of your home.
Important
The wires in this mains lead
are coloured in accordance
with the following code:
GREEN AND
YELLOW
- EARTH
BLUE
- NEUTRAL
BROWN
- LIVE
If you fit your own plug,
the colours of the wires in the
mains lead of your appliance
may not correspond with the
markings
identifying
the
terminals in your plug, this is
what you have to do:
Connect
the
green
and
yellow (earth) wire to the
terminal in the plug which is
marked with the letter «E» or
the earth
symbol
or
coloured green, or green and
yellow.
Connect the blue (neutral)
wire to the terminal in the
plug which is marked
with
the letter «N» or coloured
black.
Connect the brown (live)
wire to the terminal which is
marked with the letter «L» or
coloured red.
The plug moulded on to the
cord incorporates a fuse. For
replacement, use a 13 Amp
BS 1362 fuse.
Only ASTA approved fuses
should be used.
The fuse cover/carrier must
be replaced in the event of
changing fuse.
The right fuse cover/carrier
colour is the one shown by
the
coloured
insert
at the
base of the plug.
The plug must not be used
if the fuse cover/carrier is
lost.
A replacement
cover/car-
rier must be obtained from
Zanussi
Service
Agents
whose addresses are listed on
the attached «Zanussi Service
Force Directory» or you could
find your local agent by looking
in your
telephone
directory
under ''Z''.
This appliance complies with
E.E.C. directive no. 87/308 of
2.6.87 relative to radio inter-
ference suppression.