Zanussi FL501 Manual de instrucciones - Página 18

Navegue en línea o descargue pdf Manual de instrucciones para Lavadora Zanussi FL501. Zanussi FL501 20 páginas. Front-loading washing machine

Imprimir página

If the machine is permanently plumbed in, hook the end

of the hose into a standpipe installed for the purpose.

The standpipe must have an internal diameter of at least

40mm in order that there is an air gap between the drain

hose and the standpipe. Make sure, that it is designed in

such a way, that the end of the drain hose cannot be

covered with water.

Whether discharging into a sink or a standpipe check

that the end of the drain hose is neither too high nor too

low. The top of the curve in the hose's end should be no

3 pin

more than 90 cm, and no less than 60 cm above floor

level.

Should a prolongation of the drain hose be unavoidable

this must never surpass 1.5 m and must be of the same

diameter as the original hose

P1039

Important

Before connecting up the machine to new pipework or

to pipework that has not been used for some time, run

off a reasonable amount of water to flush out any debris

that may have collected in the pipes.

Levelling

Level the washing machine by loosening or tightening

the feet. Once in the right position fix the feet by

pushing the nuts against the base of the case

Accurate levelling prevents vibration, noise and

displacement of the machine during operation. After

levelling the machine, secure the feet by tightening the

ring nuts with the aid of a screwdriver.

Some vibration is inevitable, especially if mounted on a

P0254

P0509

wooden floor.

Sprung wooden floors are particularly susceptible to

vibration. For advice, consult a builder. If possible,

always place the machine on a solid floor.

Special conditions

If the floor is carpeted with a deep-pile carpet or

covered with crumbly or soft material, insert a rigid

support base under the feet to prevent noise, vibration or

displacement. The base should protrude a few

centimetres beyond the edges of the machine.

Warning

The machine should NOT be placed on deep pile

carpeting.

Note

Please ensure that when the appliance is installed it is

easily accessible for the engineer in the event of a

breakdown.