Zanussi ZWS76100SS Manual del usuario - Página 3
Navegue en línea o descargue pdf Manual del usuario para Lavadora Zanussi ZWS76100SS. Zanussi ZWS76100SS 41 páginas.
Imprimir página
Do not exceed the maximum load of 7 kg (refer to the
•
"Programme chart" chapter).
The operating water pressure at the water entry point from the
•
outlet connection must be between 0.5 bar (0.05 MPa) and 8
bar (0.8 MPa).
The ventilation opening in the base must not be covered by a
•
carpet, mat, or any floor covering.
The appliance must be connected to the water mains using the
•
new supplied hose sets, or other new hose sets supplied by
the Authorised Service Centre.
Old hose sets must not be reused.
•
If the mains power supply cable is damaged, it must be
•
replaced by the manufacturer, its Authorised Service Centre or
similarly qualified persons to avoid an electrical hazard.
Before any maintenance operation, deactivate the appliance
•
and disconnect the mains plug from the socket.
Do not use high pressure water sprays and/or steam to clean
•
the appliance.
Clean the appliance with a moist cloth. Use only neutral
•
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.
SAFETY INSTRUCTIONS
INSTALLATION
The installation must comply with
relevant national regulations.
•
Remove all the packaging and the transit bolts
including rubber bush with plastic spacer.
•
Keep the transit bolts in a safe place. If the
appliance is to be moved in the future they must
be reattached to lock the drum to prevent an
internal damage.
•
Always take care when moving the appliance as
it is heavy. Always use safety gloves and
enclosed footwear.
•
Follow the installation instructions supplied with
the appliance.
•
Do not install or use a damaged appliance.
•
Do not install or use the appliance where the
temperature can be less than 0°C or where it is
exposed to the weather.
•
The floor area on which the appliance is to be
installed must be flat, stable, heat resistant and
clean.
•
Make sure that there is air circulation between
the appliance and the floor.
•
When the appliance is in its permanent position,
check if it is levelled correctly with the aid of a
spirit level. If it is not, adjust the feet accordingly.
•
Do not install the appliance directly above a
floor drain.
•
Do not spray water on the appliance and do not
expose it to excessive humidity.
•
Do not install the appliance where the appliance
door cannot be fully opened.
•
Do not put a closed container to collect
possible water leakage under the appliance.
Contact the Authorised Service Centre to
ensure which accessories can be used.
3