Zanussi ZDTL 200 Manual del usuario - Página 20

Navegue en línea o descargue pdf Manual del usuario para Lavavajillas Zanussi ZDTL 200. Zanussi ZDTL 200 28 páginas. Dishwasher zdtl 200

Imprimir página

Fault code and malfunction

The programme does not start.

Once these checks have been carried out;

switch on the dishwasher. The programme will

continue from the point at which it was inter-

rupted.

If the malfunction or fault code reappears con-

tact the Service Force Centre.

For other fault codes not described in the above

chart, please contact your Service Force Cen-

tre.

Mod. :. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

The dishes are not clean

The dishes are wet and dull

• The dishwasher door has not been properly closed.

• The main plug is not plugged in.

• The fuse has blown in the household fuse box.

The wash results are not satisfactory

• The wrong washing programme has been selected.

• The dishes are arranged in such a way as to stop

• The spray arms do not rotate freely due to incorrect

• The filters in the base of the washing compartment

• Too little or no detergent has been used.

• Where there are limescales deposits on the dishes;

• The drain hose connection is not correct.

• The salt container cap is not properly closed.

• Rinse aid was not used.

• The rinse aid dispenser is empty.

Possible cause and solution

Close the door.

Insert the mains plug.

Replace the fuse.

Contact your local Service Force Centre, quot-

ing the model (Mod.), product number (PNC)

and serial number (S.N.). This information can

be found on the rating plate located on the side

of the dishwasher door.. So that you always

have these numbers at hand, we recommend

you to make a note of them here:

water reaching all parts of the surface. The baskets

must not be overloaded.

arrangement of the load.

are dirty or incorrectly positioned.

the salt container is empty or the incorrect level of

the water softener has been set.