Zanussi ZDTS 102 Manual del usuario - Página 10
Navegue en línea o descargue pdf Manual del usuario para Lavavajillas Zanussi ZDTS 102. Zanussi ZDTS 102 16 páginas.
Imprimir página
5
Different brands of detergent dissolve in different
times. Some detergent tablets do not have the best
cleaning results during short washing programmes. Use
long washing programmes when you use detergent tab-
lets to fully remove the detergent.
Use of combi detergent tablets
These tablets contain agents such as detergent, rinse aid
and dishwasher salt. Some types of tablets can contain
other agents
When you use tablets, that contain special salt and rinse
aid, it is not necessary to fill the salt and rinse aid con-
Setting and starting a washing programme
Set the washing programme with the door ajar. The
washing programme only starts after you close the
door. Until then it is possible to modify the settings.
Do these steps to set and start a washing programme:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press the programme selection/cancel button again
and again to set the washing programme. Refer to the
chapter 'Washing programmes'.
– The programme indicator light comes on.
4. Close the door.
– The washing programme starts automatically.
When the washing programme operates, you cannot
change the programme. Cancel the washing pro-
gramme.
Warning! Only interrupt or cancel a washing
programme if necessary.
Caution! Open the door carefully. Hot steam can
come free.
10
6
tainers. In this condition the rinse aid indicator light stays
on when the appliance is switched on.
1. Do a check if these tablets are applicable for the local
water hardness. Refer to the instructions from the
manufacturer.
2. Select the lowest setting for the water hardness and
rinse aid dosage.
Do these steps if the drying results are not satisfactory
1. Fill the rinse aid dispenser with rinse aid.
2. Set the rinse aid dosage to position 2.
To use normal detergent again
1. Fill the salt container and rinse aid dispenser.
2. Adjust the water hardness setting to the highest level.
3. Do a washing programme without dishes.
4. Adjust the water softener to the water hardness in your
area.
5. Adjust the rinse aid dosage.
Cancelling a washing programme
1. Press and hold the programme selection/cancel but-
ton until:
– the programme indicator light goes off.
– The end-of-programme indicator light starts to
flash.
2. Release the programme selection/cancel button to
cancel the washing programme.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme.
Fill the detergent dispenser with detergent before you set
a new washing programme.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point of interrup-
tion.
End of the washing programme
Switch off the appliance in these conditions: