Zanussi ZSFN121W1 Manual del usuario - Página 11
Navegue en línea o descargue pdf Manual del usuario para Lavavajillas Zanussi ZSFN121W1. Zanussi ZSFN121W1 25 páginas.
Imprimir página
automatically during the drying phase and remains
ajar.
AirDry is automatically activated with all
programmes other than
The duration of the drying phase and the door
opening time vary depending on the selected
programme and options.
CAUTION! Do not try to close the
appliance door within 2 minutes after
automatic opening. This can cause
damage to the appliance.
If, afterwards, the door is closed for at
least 3 minutes, the running
programme ends.
BEFORE FIRST USE
1. Make sure that the current level of the
water softener agrees with the hardness
of the water supply. If not, adjust the level
of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any processing
residuals that can still be inside the appliance.
Do not use detergent and do not put dishes in
the baskets.
After starting the programme, the appliance
recharges the resin in the water softener for up to 5
minutes. The washing phase starts only after this
procedure is complete. The procedure is repeated
periodically.
THE SALT CONTAINER
CAUTION! Use rough salt designed
for dishwashers only. Fine salt
increases the risk of corrosion.
(if applicable).
CAUTION! If children have access to
the appliance, we advise to deactivate
AirDry. The automatic opening of the
door may pose a danger.
How to deactivate AirDry
The appliance must be in programme selection
mode.
Make sure that the programme marker on the knob
is set to the on/off position.
1. To enter the user mode, press and hold
the same time turn the knob counterclockwise
until the programme marker indicates the first
programme. Release
and on/off start flashing.
2. Turn the knob counterclockwise until the
programme marker indicates the fourth
programme.
The indicator
shows the current setting:
•
is on = AirDry is activated.
•
is off = AirDry is deactivated.
3. Press
to change the setting.
4. To confirm the setting, keep turning the
programme knob until the programme marker is
back in the on/off position.
The salt is used to recharge the resin in the water
softener and to assure good washing results in
daily use.
HOW TO FILL THE SALT CONTAINER
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt container (only for
the first time).
3. Fill the salt container with 1 kg of salt (until it is
full).
. At
when the indicators
11