Zanussi ZEI6640XBA Manual del usuario - Página 11
Navegue en línea o descargue pdf Manual del usuario para Placa Zanussi ZEI6640XBA. Zanussi ZEI6640XBA 20 páginas. Induction hob
También para Zanussi ZEI6640XBA: Manual del usuario (16 páginas), Manual del usuario (20 páginas), Manual del usuario (20 páginas)
Imprimir página
Problem
An acoustic signal sounds and the
appliance deactivates.
An acoustic signal sounds when
the appliance is deactivated.
The appliance deactivates.
The residual heat indicator does
not come on.
The heat setting changes between
two levels.
The sensor fields become hot.
comes on.
comes on.
comes on.
and a number come on.
comes on.
If you tried the above solutions and cannot re-
pair the problem, speak to your dealer or the
customer service. Give the data from the rating
www.zanussi.com
Possible cause
There is water or fat stains on the
control panel.
You put something on one or
more sensor fields.
You put something on the sensor
field
.
The cooking zone is not hot be-
cause it operated only for a short
time.
The Power management is acti-
vated.
The cookware is too large or you
put it too near to the controls.
The Automatic Switch Off oper-
ates.
The Child Safety Device or the
Lock function operates.
No cookware is on the cooking
zone.
The cookware is incorrect.
The diameter of the bottom of the
cookware is too small for the
cooking zone.
There is an error in the appliance.
There is an error in the appliance
because a cookware boils dry.
The overheating protection for the
cooking zones and the Automatic
Switch Off operate.
plate, three digit letter code for the glass ce-
ramic (it is in the corner of the glass surface)
and an error message that comes on.
Remedy
Clean the control panel.
Remove the object from the sensor
fields.
Remove the object from the sensor
field.
If the cooking zone operated suffi-
ciently long to be hot, speak to the
service centre.
Refer to "Power management".
Put large cookware on the rear
cooking zones if necessary.
Deactivate the appliance and acti-
vate it again.
Refer to the chapter "Daily Use".
Put cookware on the cooking zone.
Use the correct cookware.
Move cookware to a smaller cook-
ing zone.
Disconnect the appliance from the
electrical supply for some time.
Disconnect the fuse from the elec-
trical system of the house. Connect
it again. If
comes on again,
speak to the service centre.
Deactivate the appliance. Remove
the hot cookware. After, approxi-
mately 30 seconds, activate the
cooking zone again. If the cook-
ware was the problem, the error
message goes out of the display,
but the residual heat indicator can
stay. Let the cookware become
sufficiently cool and refer to
"Cookware for the induction cook-
ing zone" to see if your cookware
is compatible with the appliance.
11