Zanussi ZEV6646XBA Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Placa Zanussi ZEV6646XBA. Zanussi ZEV6646XBA 16 páginas. Hob zev6646xba
También para Zanussi ZEV6646XBA: Manual del usuario (12 páginas), Manual del usuario (16 páginas), Manual del usuario (17 páginas)

Imprimir página

Problem

You cannot activate the outer

ring.

The sensor fields become hot.

comes on.

and a number come on.

If you tried the above solutions and cannot re-

pair the problem, speak to your dealer or the

customer service. Give the data from the rating

plate, three digit letter code for the glass ce-

ramic (it is in the corner of the glass surface)

and an error message that comes on.

Installation instructions

Warning! Refer to the Safety chapters.

Before the installation

Before the installation of the appliance, record

the information below from the rating plate. The

rating plate is on the bottom of the appliance

casing.

• Model ...........................

• PNC .............................

• Serial number ....................

Built-in appliances

• Only use the built-in appliances after you as-

semble the appliance into correct built-in

Possible cause

You decreased the heat setting

from

The cookware is too large or you

put it too near to the controls.

The Automatic Switch Off oper-

ates.

The Child Safety Device or the

Lock function operates.

There is an error in the appliance.

Make sure, you operated the appliance correct-

ly. If not the servicing by a customer service

technician or dealer will not be free of charge,

also during the warranty period. The instruc-

tions about the customer service and condi-

tions of guarantee are in the guarantee booklet.

Connection cable

• Use the correct mains cable of type H05BB-

• Replace the damaged mains cable with a

Start from

heat setting.

Activate the inner ring first.

Put large cookware on the rear

cooking zones if necessary.

Deactivate the appliance and acti-

vate it again.

Refer to the chapter "Daily use".

Disconnect the appliance from the

electrical supply for some time.

Disconnect the fuse from the elec-

trical system of the house. Connect

it again. If

speak to the service centre.

units and work surfaces that align to the

standards.

F Tmax 90°C (or higher) for a single phase or

two phase connection.

special cable (type H05BB-F Tmax 90°C or

higher). Speak to your local Service Centre.

Remedy

and only increase the

comes on again,