Zanussi ZEV6646XBA Manual del usuario - Página 3

Navegue en línea o descargue pdf Manual del usuario para Placa Zanussi ZEV6646XBA. Zanussi ZEV6646XBA 12 páginas. Hob zev6646xba
También para Zanussi ZEV6646XBA: Manual del usuario (16 páginas), Manual del usuario (16 páginas), Manual del usuario (17 páginas)

Imprimir página

The Safety Instructions

Warning! You must read these!

• Make sure that the appliance is not damaged because

of transportation. Do not connect a damaged appliance.

If it is necessary, speak to the supplier.

• Only an authorized servicing technician can install,

connect or repair this appliance. Use only original

spare parts.

• Only use the built-in appliances after you assemble the

appliance into correct built-in units and work surfaces

that align to the standards.

• Do not change the specifications or change this prod-

uct. Risk of injury and damage to the appliance.

• Fully obey the laws, ordinances, directives and stand-

ards in force in the country where you use the appli-

ance (safety regulations, recycling regulations, electri-

cal safety rules etc.)!

• Keep the minimum distances to other appliances and

units!

• Install shock protection, for example install the drawers

only with a protective floor directly below the appli-

ance!

• Keep safe the cut surfaces of the worktop from mois-

ture with a correct sealant!

• Seal the appliance to the work top with no space be-

tween with a correct sealant!

• Keep safe the bottom of the appliance from steam and

moisture, e.g. from a dishwasher or oven!

• Do not install the appliance adjacent to doors and be-

low windows! If not, when you open the doors or win-

dows they can push off hot cookware from the appli-

ance.

Warning! Risk of injury from electrical current.

Carefully obey the instructions for electrical

connections.

• The electrical mains terminal is live.

• Make electrical mains terminal free of voltage.

• Install correctly to give shock protection.

• Loose and incorrect plug and socket connections can

make the terminal become too hot.

• A qualified electrician must install the connections in

the clamps correctly.

• Use a strain relief clamp on cable.

• Use the correct mains cable of type H05BB-F Tmax

90°C (or higher) for a single phase or two phase con-

nection.

• Replace the damaged mains cable with a special cable

(type H05BB-F Tmax 90°C; or higher). Speak to your

local Service Centre.

The appliance must have the electrical installation which

lets you disconnect the appliance from the mains at all

poles with a contact opening width of minimum 3 mm.

You must have correct devices to isolate: line protecting

cut-outs, fuses (screw type fuses removed from the hold-

er), earth leakage trips and contactors.