Zanussi ZGF 6420 Manual de instrucciones - Página 5

Navegue en línea o descargue pdf Manual de instrucciones para Placa Zanussi ZGF 6420. Zanussi ZGF 6420 16 páginas.

Imprimir página

Cast Iron Pan Supports

The hob has cast iron pan supports.

Take care when removing them. They are very heavy and

could damage the hob or your kitchen furniture if you let

them fall down.

To keep the pan supports in the correct position, they

are hooked into hinges at the back of the hob. When

removing the pan supports, lift them up as shown in the

diagram. Never turn the pan supports on the hinges, this

could damage them.

Wash the pan supports using hot soapy water. If

necessary, a paste cleaner or a soap impregnated steel

wool pad can be used with caution.

After cleaning, be sure to wipe dry with a soft cloth.

The Burners

The burner caps and crowns (Fig. 1) can be removed for

cleaning. Wash the burner caps and crowns using hot

soapy water, and remove marks with a mild paste cleaner.

A well moistened soap impregnated steel wool pad can

be used with caution, if the marks are particularly difficult

to remove. After cleaning, be sure to wipe dry with a soft

cloth.

Ignition Electrode

The electric ignition is obtained through a ceramic

"electrode" and a metal electrode (Fig. 1 - letter C).

Keep these components very clean, to avoid lighting

difficulties, and check that the burner crown holes are

not obstructed.

Something Not Working?

If the hob is not working correctly, please carry out the following checks before contacting your local Zanussi Service

Force Centre.

IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or

installation, a charge will be made even if the appliance is under guarantee.

SYMPTOM

There is no spark when lighting the gas

The gas ring burns unevenly

SOLUTION

Check that the unit is plugged in and the electrical

supply is switched on

Check that the RCCB has not tripped (if fitted)

Check the mains fuse has not blown

Check the burner cap and crown have been

replaced correctly, e.g. after cleaning.

Check the main jet is not blocked and the burner

crown is clear of food particles.

Check the burner cap and crown have been

replaced correctly, e.g. after cleaning.

YES