Zanussi ZGF 681 IX Manual de instrucciones - Página 4
Navegue en línea o descargue pdf Manual de instrucciones para Placa Zanussi ZGF 681 IX. Zanussi ZGF 681 IX 12 páginas.
Imprimir página
Operation
Hob Burners
F
To light a burner:
push in the relevant control knob and turn it
l
anticlockwise to maximum position;
upon ignition, keep the knob pushed down about 5
l
seconds. This will allow the "thermocouple" (Fig. 1 -
letter D) to be heated and the safety device to be
switched off, otherwise the gas supply would be
interrupted;
then adjust the flame as required.
l
If the burner does not ignite, turn the control knob to
zero, and try again.
To ensure maximum burner efficiency, you should only
use pots and pans with a flat bottom fitting the size of
the burner used (see table).
Burner
Large (double-crown)
Medium (semi-rapid)
Small (Auxiliary)
If you use a saucepan which is smaller than the
recommended size, the flame will spread beyond
the bottom of the vessel, causing the handle to
overheat.
As soon as a liquid starts boiling, turn down the
flame so that it will barely keep the liquid
simmering.
Take care when frying food in hot oil or fat, as
the overheated splashes could easily ignite.
If the control knobs become difficult to turn, please
contact your local Service Centre.
Using the Wok Stand
A wok stand is provided to enable you to use a round
bottomed wok on the hob. The wok stand must only be
used on the double crown burner, and should not be used
with any other type of wok or pan.
When fitting the wok stand, ensure the recesses in the
frame fit securely onto the bars of the pan supports, as
shown in the diagram.
4
All manuals and user guides at all-guides.com
minimum
maximum
diameter
diameter
180 mm.
260 mm.
120 mm.
220 mm.
80 mm.
160 mm.
A - Burner cap
B - Burner crown
C - Ignition electrode
D - Thermocouple
Fig. 1