Zanussi ZGG 642 Manual de instrucciones - Página 10
Navegue en línea o descargue pdf Manual de instrucciones para Placa Zanussi ZGG 642. Zanussi ZGG 642 20 páginas. Gas hobs
También para Zanussi ZGG 642: Manual de instrucciones (16 páginas), Manual de instrucciones (20 páginas), Manual de instrucciones (16 páginas), Manual de instrucciones (16 páginas), Manual de instrucciones (16 páginas), Manual de instrucciones (16 páginas)
Imprimir página
Building In
Building over a cupboard or
drawer
If the hob is to be installed above a cupboard or drawer
it will be necessary to fit a heat resistant board below
the base of the hob on the underside of the work surface.
It is also recommended to carry out the electrical
connection to the hob as shown in diagrams 1 and 2.
ON/OFF SWITCH
FLEX
OUTLET
FO 0763
Fitting the hob to the worktop
Before fitting the hob into the cut out, an adhesive seal
must be fitted to the underside outside edge (diagram 4)
of the hob. It is essential that no gaps are left in this seal
in order to prevent spillage near the hob seeping into the
cabinet below.
1) Remove the pan supports, the burners caps
and crowns and turn the hob upside down,
taking care the ignition candles are not
damaged in this operation.
2) Place the sealing gasket all around the glass
top edge as shown in diagram 4.
3) Fit the hob in the cut out and push it down
until the glass top and the working top make
contact, as shown in diagram 5.
10
1
ON/OFF SWITCH
FLEX
OUTLET
FO 0764
Building over a kitchen unit with
door
Proper arrangements must be taken in designing the
furniture unit, in order to avoid any contact with the
bottom of the hob which can be heated when it is
operated. The recommended solution is shown in
diagram 3.
The panel fitted under the hob ("a") should be easily
removable to allow easy access if technical assistance
is needed. The space behind the kitchen unit ("b") can
be used for connections.
2
FO 1013
Dimensions are given in mm.
FO 2320
FO 2107
3
4
5
A
A) Sealing gasket