Zanussi ZGO76534 Manual del usuario - Página 8
Navegue en línea o descargue pdf Manual del usuario para Placa Zanussi ZGO76534. Zanussi ZGO76534 16 páginas.
También para Zanussi ZGO76534: Manual del usuario (48 páginas)
Imprimir página
Operation
Ignition of the burner
Warning! Be very careful when you use open fire in
kitchen environment. Manufacturer decline any
responsibility in case misuse of the flame
Always light the burner before you put cookware.
To light the burner:
1.
Turn the control knob counterclockwise to the maxi-
mum position (
2.
Keep the control knob pushed for approximately 5
seconds; this will let thermocouple to warm up. If
not, the gas supply will be interrupted.
3.
Adjust the flame after it is regular.
If after some tries the burner does not light, check if
the crown and its cap are in correct positions.
Burner cap and crown
1
Thermocouple
2
Ignition candle
3
8
) and push it down.
1
2
3
Burner cap
1
Burner crown
2
Ignition candle
3
Thermocouple
4
Warning! Do not keep the control knob pushed for
more than 15 seconds.
If the burner does not light after 15 seconds, release the
control knob, turn it into off position and try to light the
burner again after minimum 1 minute.
Important! In the absence of electricity you can ignite the
burner without electrical device; in this case approach the
burner with a flame, push the relevant knob down and turn
it counter-clockwise to maximum gas release position.
If the burner accidentally goes out, turn the control
knob to the off position and try to light the burner
again after minimum 1 minute.
The spark generator can start automatically when
you switch on the mains, after installation or a pow-
er cut. It is normal.
Turning the burner off
To put the flame out, turn the knob to the symbol
Warning! Always turn the flame down or switch it off
before you remove the pans from the burner.
1
2
3
4
.
www.zanussi.com