Zanussi ZKT 630 D Libro de instrucciones - Página 18

Navegue en línea o descargue pdf Libro de instrucciones para Placa Zanussi ZKT 630 D. Zanussi ZKT 630 D 22 páginas. Glass ceramic induction hob

Safety Instructions for the Installer

• A fixture must be provided in the electrical instal-

lation which allows the appliance to be discon-

nected from the mains at all poles with a contact

opening width of at least 3 millimetres.

Suitable isolation devices include, e.g. cut-outs,

fuses (screw type fuses are to be removed from

the holder), earth leakage trips and contactors.

• In respect of fire protection, this appliance corre-

sponds to type Y (IEC 335-2-6). Only this type of

appliance may be installed with a high cupboard

or wall on one side.

• It is not permitted to fit drawers underneath the

cooking surface.

• Shock protection must be provided by the instal-

lation.

• The kitchen unit in which the appliance is fitted

must satisfy the requirements of DIN 68930 in

respect of stability.

• For protection against moisture, all cut surfaces

are to be sealed with a suitable sealant.

• On tiled work surfaces, the joints in the area

where the hob sits must be completely filled with

grout.

• On natural, artificial stone, or ceramic tops, the

snap action springs must be bonded in place

using sythetic resin or separate application adhe-

sive.

• Ensure that the seal is correctly seated in the

frame and that it is seated against the work sur-

face without leaving any gaps. Additional silicon

sealant must not be applied, this will make remo-

val more difficult in the event of the need for ser-

vice.

• To remove the hob, it must be pressed out from

below.