Zanussi ZKT 641 H Manual de instrucciones de instalación y funcionamiento - Página 18
Navegue en línea o descargue pdf Manual de instrucciones de instalación y funcionamiento para Placa Zanussi ZKT 641 H. Zanussi ZKT 641 H 32 páginas. Zanussi installation and operating instructions ceramic hob zkt 641 h
También para Zanussi ZKT 641 H: Manual de instrucciones de instalación y funcionamiento (28 páginas)
Imprimir página
What to do if ...
Problem
The cooking zones will not
switch on or are not function-
ing
Acoustic signal sounds when
appliance is switched off
The residual heat indicator is
not displaying anything
The automatic warm up func-
tion is not switching itself on
Acoustic signal sounds and
appliance switches itself on
and then off again; after 5
seconds another acoustic
signal sounds
_
is lit
18
Possible cause
More than 10 seconds have
passed since the appliance
was switched on
The child safety device is
l
switched on
Several sensor fields were
touched at the same time
Automatic switch off has
been triggered
The lock is switched on
The control panel is wholly or
partly covered by objects.
The cooking zone was only
on for a short time and is
therefore not hot
There is still residual heat on
the cooking zone h
The highest heat setting is
set Ç
The heat setting was set us-
ing the sensor field
The On/Off sensor field has
been covered up, e.g. by a
cloth
Overheating protection for
the cooking zone has been
triggered
Automatic switch off has
been triggered
Remedy
Switch the appliance on
again.
Deactivate the child safety
device (See the section
"Child safety device")
Only touch one sensor field
Remove any objects (pan,
cloths, etc.) that are lying on
the control panel. Switch the
appliance on again
l
Switch off the lock (See the
section "Locking/unlocking
the control panel")
Remove objects.
If the cooking zone is sup-
posed to be hot, call your lo-
cal Service Force Centre.
Let the cooking zone cool
down
The highest heat setting has
the same power as the auto-
matic warm up function
1. Switching off the cooking
zone
1. Set the cooking zone using
the sensor field
Do not place any objects on
the control panel
Switch off the cooking zone.
Switch the cooking zone on
again
Switch off the cooking zone.
Switch the cooking zone on
again