Zanussi ZBB28441SA Manual del usuario - Página 9
Navegue en línea o descargue pdf Manual del usuario para Congelador Zanussi ZBB28441SA. Zanussi ZBB28441SA 32 páginas. Zanussi zbb28441sa fridge-freezer user manual
También para Zanussi ZBB28441SA: Manual del usuario (16 páginas), Manual del usuario (49 páginas), Manual del usuario (29 páginas), Manual de inicio rápido (12 páginas)
Imprimir página
Problem
The lamp does not work.
The compressor operates
continually.
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Water flows on the
ground.
The temperature in the ap-
pliance is too low/high.
The temperature in the re-
frigerator is too high.
The temperature in the
freezer is too high.
There is too much frost.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
www.zanussi.com
Possible cause
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set correct-
ly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too
high.
The room temperature is too high.
During the automatic defrosting
process, frost defrosts on the rear
plate.
The water outlet is clogged.
Products prevent that water flows
into the water collector.
The melting water outlet does not
flow in the evaporative tray above
the compressor.
The temperature regulator is not
set correctly.
There is no cold air circulation in
the appliance.
Products are too near to each oth-
er.
Food is not wrapped correctly.
The door is not closed correctly.
The temperature regulator is not
set correctly.
Solution
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature before
storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Set a higher/lower temperature.
Make sure that there is cold air cir-
culation in the appliance.
Store products so that there is cold
air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
9