Zanussi ZC240F Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Congelador Zanussi ZC240F. Zanussi ZC240F 10 páginas. Freezer zc240f

Imprimir página

INSTALLATION

If this appliance – equipped with magnetic door

seals – replaces an older appliance featuring a

spring lock (mechanical latch) on the door or lid,

please ensure that this lock is made completely

unusable before «throwing out» the old appliance.

This will prevent it from becoming a death-trap for

a child.

Location

Place the appliance as far away as possible from

sources of heat, e.g. radiators, heaters, direct

sunlight, etc. The best results are achieved with a

room temperature of between +18 C and +43 C.

Make sure that there is nothing hindering air

circulation at the back, bottom or top of the

appliance. To achieve the best performance, the top

of the appliance – if set under a wall cabinet – should

be at least 5 mm away from the base of the cabinet

(Figure 1-A). However, the appliance should ideally

not be installed underneath wall cabinets (as shown

in Figure 1-B).

It can be positioned with its sides set tight against

adjacent furniture as long as air is able to circulate

freely behind and above it.

One or more adjustable feet mounted on the base of

the appliance make it possible to set it perfectly

level.

D174

Fig. 1

Power connection

Before plugging in the appliance to the mains

socket, check that the voltage and frequency

indicated on the appliance's rating plate are the

same as those provided by your home power supply.

A 6% ﬂuctuation above or below rated voltage is

acceptable. For operation using different voltages,

you should use an autotransformer of suitable

capacity.

The appliance MUST be connected to an efficient earth or

ground tap.

The supply-lead plug in fact incorporates a special

earth or ground contact for this purpose.

If by any chance the sockets of your domestic wiring

system are not earthed, the appliance must be

connected to a separate earth or ground wire by a

qualiﬁed electrician, in accordance with existing

safety regulations.

The manufacturer declines to accept any liability if this

accident-prevention procedure is not followed.

This appliance complies with EEC directive number 87/

308 of 2/6/87 relative to radio interference suppression.

This appliance complies with the following

E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage Directive) and

subsequent modiﬁcations;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modiﬁcations.

Cleaning the appliance's interior

Before using the appliance for the ﬁrst time, wash

all internal parts with lukewarm water and neutral

soap so as to remove the typical «new» smell and

then dry thoroughly. Do not use detergents or

abrasive powders as these will damage the ﬁnish.