Zanussi ZFC627WAP Manual del usuario - Página 10
Navegue en línea o descargue pdf Manual del usuario para Congelador Zanussi ZFC627WAP. Zanussi ZFC627WAP 13 páginas. Chest
También para Zanussi ZFC627WAP: Manual del usuario (8 páginas), Manual del usuario (12 páginas), Manual del usuario (12 páginas)
Imprimir página
POSITIONING
CAUTION! If you are discarding an
old appliance that has a lock or catch
on the lid, you must ensure that it is
made unusable to prevent young
children being trapped inside.
This appliance can be installed in a dry, well
ventilated indoor where the ambient temperature
corresponds to the climate class indicated on the
rating plate of the appliance:
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Some functional problems might occur
for some types of models when
operating outside of that range. The
correct operation can only be
guaranteed within the specified
temperature range. If you have any
doubts regarding where to install the
appliance, please turn to the vendor,
to our customer service or to the
nearest Service Centre
The appliance shall have the plug
accessible after installation.
ELECTRICAL CONNECTION
CAUTION! Any electrical work
required to install this appliance
should be carried out by a qualified
electrician or competent person.
WARNING! This appliance must be
earthed.
The manufacturer declines any liability
should these safety measures not be
observed.
The wires in the mains lead are coloured in
accordance with the following code:
10
A
•
A - green and yellow: Earth
•
C - brown: Live
•
D - blue: Neutral
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
1. Connect the wire coloured green and yellow to
the terminal marked either with the letter "E" or
by the earth symbol
yellow.
2. Connect the wire coloured blue to the terminal
either marked with the letter "N" or coloured
black.
3. Connect the wire coloured brown to the
terminal either marked with the "L" or coloured
red.
4. Check that no cut, or stray strands of wire is
present and the cord clamp (E) is secure over
the outer sheath.
Make sure the electricity supply voltage is the
same as that indicated on the appliance rating
plate.
5. Switch on the appliance.
The appliance is supplied with a 13 amp fuse (B).
In the event of having to change the fuse in the plug
supplied, a 13 amp ASTA approved (BS 1362)
fuse must be used.
WARNING! A cut off plug inserted
into a 13 amp socket is a serious
safety (shock) hazard. Ensure that it is
disposed of safely.
B
C
D
E
or coloured green and