Zanussi ZFT710W Manual del usuario - Página 35

Navegue en línea o descargue pdf Manual del usuario para Congelador Zanussi ZFT710W. Zanussi ZFT710W 41 páginas. Freezer
También para Zanussi ZFT710W: Manual del usuario (16 páginas)

Imprimir página

Location

The appliance should be installed well away from sources of heat

such as radiators, boilers, direct sunlight etc. Ensure that air can

circulate freely around the back of the cabinet. To ensure best per-

formance, if the appliance is positioned below an overhanging wall

unit, the minimum distance between the top of the cabinet and the

wall unit must be at least 100 mm . Ideally, however, the appliance

should not be positioned below overhanging wall units. Accurate

levelling is ensured by one or more adjustable feet at the base of the

cabinet.

If the cabinet is placed in a corner and the side with the hinges fac-

ing the wall, the distance between the wall and the cabinet must be

at least 10 mm to allow the door to open enough so that the shelves

can be removed.

Door reversibility

Important! To carry out the following operations, we

suggest that this be made with another person that will

keep a firm hold on the doors of the appliance during the

operations.

1. Remove the plug from

the power socket.

2. Tilt back the appliance

carefully so that the com-

pressor cannot touch the

floor.

3. Unscrew the adjustable

feet, situated on both sides

at the front.

1) If foreseen

Do a final check to make sure that:

• All screws are tightened.

4. Remove the lower door

hinge by unscrewing the 2

retaining screws.

5. Remove the hinge pin

from the bottom of the

door.

6. Slot the hinge pin into

the hole in the hinge plate.

7. Take the door off.

8. Refit the upper hinge pin

into the opposite location.

9. Fit the door in place on

the hinge pin.

Warning!

It must be possible to disconnect the appliance

from the mains power supply; the plug must

therefore be easily accessible after installation.

To change the opening direction of the door, do these

steps:

10. Slot the hinge pin into

the hole in the hinge plate

and relocate the hinge as-

sembly to the opposite lo-

cation and refit using the

retaining screws.

11. Refit the bottom hinge

plate assembly on the op-

posite side, taking care that

the edge of the door is par-

allel with the side of the

cabinet.

• The door opens and closes correctly.

12. Remove and install the

handle

on the opposite

side.

13. Reposition, level the

appliance, wait for at least

four hours and then con-

nect it to the power socket.