Zanussi ZTAN24FW0 Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Congelador Zanussi ZTAN24FW0. Zanussi ZTAN24FW0 21 páginas.
También para Zanussi ZTAN24FW0: Manual del usuario (21 páginas)

Imprimir página

2. Connect the wire coloured blue to the terminal

either marked with the letter "N" or coloured

black.

3. Connect the wire coloured brown to the

terminal either marked with the "L" or coloured

red.

4. Check that no cut, or stray strands of wire is

present and the cord clamp (E) is secure over

the outer sheath.

Make sure the electricity supply voltage is the

same as that indicated on the appliance rating

plate.

5. Switch on the appliance.

The appliance is supplied with a 13 amp fuse (B).

In the event of having to change the fuse in the plug

supplied, a 13 amp ASTA approved (BS 1362)

fuse must be used.

WARNING! A cut off plug inserted

into a 13 amp socket is a serious

safety (shock) hazard. Ensure that it is

disposed of safely.

REAR SPACERS

In the bag with the documentation, there are two

spacers which must be fitted as shown in the

figure.

DOOR REVERSIBILITY

WARNING! Before carrying out any

operations, remove the plug from the

power socket.

Empty the appliance.

1. Make sure the appliance stands upright.

2. Open both doors and remove the door

equipment. Refer to "Daily Use" chapter. Close

the doors.

3. Use a thin-blade screwdriver to remove the

screw hole cover (A) and the upper hinge

cover (B). Put them aside.

4. Unscrew the screws of the right upper hinge.

Support the upper door with your hand.

Remove the upper hinge, reverse it, screw the

screws and the pin to it. Put the hinge aside.

5. Carefully lift the upper door from the middle

hinge to remove it. Place the upper door on the

soft surface. Be careful not to lose washers

that may stick to the door.

6. Unscrew the screw (B) and the "stop block" (A)

and screw them on the opposite side of the

door.

7. Unscrew the screws from the middle hinge.

Remove the middle hinge and put it aside

together with the screws.