Zanussi ZTAN24FW0 Manual del usuario - Página 7
Navegue en línea o descargue pdf Manual del usuario para Congelador Zanussi ZTAN24FW0. Zanussi ZTAN24FW0 21 páginas.
También para Zanussi ZTAN24FW0: Manual del usuario (21 páginas)
Imprimir página
In case of different installation from freestanding
respecting space required in use dimensions, the
appliance will function correctly but energy
consumption might increase slightly.
To ensure appliance's best functionality, you should
not install the appliance in the nearby of the heat
source (oven, stoves, radiators, cookers or hobs) or
in a place with direct sunlight. Make sure that air
can circulate freely around the back of the cabinet.
This appliance should be installed in a dry, well
ventilated indoor position.
To ensure best performance, if the appliance is
positioned below an overhanging wall unit, the
minimum distance between the top of the cabinet
shall be maintained. Ideally, however, the appliance
should not be positioned below overhanging wall
units. One or more adjustable feet at the base of
the cabinet ensure that the appliance stands level.
CAUTION! If you position the
appliance against the wall, use back
spacers provided or keep the minimum
distance indicated in the installation
instructions.
CAUTION! If you install the appliance
next to a wall, refer to the installation
instructions to understand the
minimum distance between the wall
and the side of the appliance where
door hinges are to provide enough
space to open the door when the
internal equipment is removed (e.g.
when cleaning).
This appliance is intended to be used at ambient
temperature ranging from 10°C to 38°C.
The correct operation of the appliance
can only be guaranteed within the
specified temperature range.
If you have any doubts regarding
where to install the appliance, please
turn to the vendor, to our customer
service or to the nearest Authorised
Service Centre.
It must be possible to disconnect the
appliance from the mains power
supply. The plug must therefore be
easily accessible after installation.
ELECTRICAL CONNECTION
•
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.
•
The appliance must be earthed. The power
supply cable plug is provided with a contact for
this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
•
The manufacturer declines all responsibility if
the above safety precautions are not observed.
•
This appliance complies with the E.E.C.
Directives.
REAR SPACERS
In the bag with the documentation, there are two
spacers which must be fitted as shown in the
figure.
If you position the appliance against a wall in a
freestanding installation, install the rear spacers in
order to guarantee the maximum possible distance.
DOOR REVERSIBILITY
WARNING! Before carrying out any
operations, remove the plug from the
power socket.
Empty the appliance.
1. Make sure the appliance stands upright.
2. Open both doors and remove the door
equipment. Refer to "Daily Use" chapter. Close
the doors.
3. Use a thin-blade screwdriver to remove the
screw hole cover (A) and the upper hinge
7