Directed Directechs DB3 Manual de instalación - Página 6

Imprimir página

Directed Directechs DB3 Manual de instalación

Immobilizer interface

When possible use valet key for key wrap. If a blade key is used or

from OEM key (the OEM remote may differ from the models shown in the illustrations).

removed

Make sure to test and secure the loops before reassembling the vehicle.

Method 1: Key Wrap

4-6 loops

Note:

- Your OEM remote may differ from the model shown in the illustrations.

- Make 4-6 loops and place them around the front of the plastic body of the vehicle's coded key as shown above.

- Test and secure mounted loops before reassembling the vehicle.

Method 2: Immobilizer interface using 556UXL (sold separately)

Not all OEM remotes can be inserted in 556UXL because of their size.

Make sure the key will fit, otherwise it is recommended to use a different method.

Note: The discontinued 556U or 556UW can still be used for the installation.

Common Relay 2: Yellow/Red: 11

NO Relay 2: Brown/Red: 12

403.VW10 2.01 2008 Volkswagen Passat

The OEM immobilizer

receiver is located on the

underside of the steering

column, where the ignition

switch would normally be.

4-6 loops

if the vehicle is equipped with Keyless Entry

Common Relay 2: Yellow/Red: 11

NO Relay 2: Brown/Red: 12

Remove battery from

OEM Remote Control

Move 556UXL loop as close to the

front of ignition cylinder (OEM

Immobilizer Receiver) as possible.

Test and secure mounted loop

before reassembling the vehicle.

N/A: Green, pin 6

N/A: Violet, pin 5

(-) Ground: Black, pin 4

N/A: Pink, pin 3

(-) GWR: Blue, pin 2

(+)12V : Red, pin 1

, the battery must be

OEM

Immobilizer

Receiver

Black/White - NOT USED

Black/Red

Black

(+)12V