Zanussi ZHP 625 Manual de instalación, uso y mantenimiento - Página 12
Navegue en línea o descargue pdf Manual de instalación, uso y mantenimiento para Campana de ventilación Zanussi ZHP 625. Zanussi ZHP 625 40 páginas.
También para Zanussi ZHP 625: Manual de instrucciones (40 páginas)
INSTALLATION
Drilling the Support surface and Fitting the Hood
• The hood support surface must be 135 mm above the bottom
surface of the wall units.
• Drill the support with a ø 4,5 mm drill bit, using the drilling
template provided.
• Cut a hole ø 125 mm in size on the support surface, using the
drilling template provided.
• Fix using the 4 screws 12a (4,2 x 44,4) provided.
• The hood can be installed either directly on the bottom surface
of the wall units using snap-on side supports.
• Cut a fitted opening in the bottom surface of the wall unit, as
shown.
• Insert the hood until the side supports snap into place.
• Lock in position by tightening the screws Vf from underneath
the hood.
• The space between the edge of the hood and the rear wall can
be closed by applying the element 20 provided, using the
screws supplied for this purpose.
EN
SCREW FITTING
SNAP-ON FITTING
CLOSING ELEMENT
Downloaded from www.vandenborre.be
12a
125
125
264
15
Vf
20
1
12
2