Zanussi ZCM 5262 Libro de instrucciones - Página 11

Navegue en línea o descargue pdf Libro de instrucciones para Cocinas Zanussi ZCM 5262. Zanussi ZCM 5262 21 páginas. Electric gas cooker zcm 5262

Imprimir página

Ignition of the burners

1. Push the knob and turn it left to the "large

flame" symbol.

2. At the same time, push the electronic

ignition knob (fig. 11) for obtaining sparkles.

Keep it pushed till turning up of the flame (1

spark / second).

Lack of power

1. Push the corresponding knob in completely

and turn it left to the "large flame" symbol and

ignite with a match.

2. Hold a flame to the gas oven burner holes.

3. The hob burners are provided with a safety

device. The control knob must be pressed

in for approximately 10 seconds until the

safety valve automatically keeps the flame

lit.

4. Release the knob and watch that the burner

has ignited. Upon ignition, adjust the flame as

required.

If for any reason the flame should extinguish turn

off the relevant control know, leave for at least

one minute and then re-ignite.

If after a few attempts the burner does not ignite,

check that the burner ring and its cap are

correctly positioned (fig. 12).

Extinguishing of burners

Turn the knob clockwise to mark «

device is in place.

Do not put anything on the hob that is

liable to melt.

Electric Hotplates

To switch on a hotplate, turn the relevant control

knob to the required heat setting.

The control knob is numbered 0 – 6

0 – OFF

1 – Minimum

6 – Maximum.

The hob has two types of hotplates:

Normal Hotplates

We recommend the plates are switched to

maximum (6) for a short while to boost the plate,

and then adjusted to the required setting.

Rapid Hotplate (Back left)

The rapid hotplates indicated by a red spot, will

heat up more quickly than a normal plate.

fig. 11

fig. 12

». The safety

fig. 13

Burner cap

Burner

ring

Ignition

Thermocouple

(safety device)