Zanussi ZKG5540 Manual del usuario - Página 39

Navegue en línea o descargue pdf Manual del usuario para Cocinas Zanussi ZKG5540. Zanussi ZKG5540 44 páginas. Range cookers
También para Zanussi ZKG5540: Manual del usuario (44 páginas), Características y funciones (9 páginas)

Imprimir página

The stability chain anchor point on the

appliance is shown below.

Pressure testing

The Rapid injector is used as a pressure

test point.

Connect the pressure gauge to the Rapid

injector.

Check the supply pressure by turning the

Rapid burner on and one other hotplate

burner full on and light the appropriate

burner. The pressure should be 20mbar

Turn off the taps, disconnect the pressure

gauge.

Check operation of each hotplate burner.

Checking the grill

1. Place the grill pan containing the grid, with

the handle attached, into the grill

compartment. Light the grill burner by turning

the grill tap full on and pressing the ignition

button on the fascia panel. As soon as the

burner is lit the button can be released.

Checking the hob

1. Lift the lid. Fit the burner crowns and caps

ensuring that they are correctly seated. Fit

the pan supports.

2. Check each of the hob burners in turn by

turning the hob tap to its full on position and

pressing the ignition button. As soon as the

burners are lit the button can be released.

Checking the lid shut-off device

1. Lift the lid

2. Turn one hotplate tap to its full on position

and push the ignition button.

3. Close the lid. There should now be no gas

supply to the hotplate and the burner will go

out.

4. Turn off the hotplate and lift the lid. The gas

supply should now be restored to the

hotplate, when the tap is turned on.

Checking the top oven

1. Turn the top oven thermostat control knob to

Mk.1 and press the ignition button. As soon

as the burner is alight the button can be

released.

2. When the oven burner lights up there should

be a low gas rate at first to the oven burner,

which is the F.S.D. bypass rate.

3. When the F.S.D. phial has heated up it

opens the F.S.D. valve and the main gas

stream flows to the burner.

4. After 1 minute check that the flame covers

the full width of the burner and is stable.

5. Set the oven control to Mk. 2, close the oven

door and check that after about 10 minutes

the flame size has reduced.

6. Turn off the control knob and check that the

oven flames go out.