Alecto DBX-82 Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Vigilabebés Alecto DBX-82. Alecto DBX-82 17 páginas.

HOW TO USE

ON / OFF SWITCH:

Baby unit:

Switch on the baby unit located on the right side of the baby unit by sliding the on

/ off switch to position 1. This will allow to switch the channel.

Slide this switch to the 0 position in order to turn the baby unit off.

Parent unit:

Press and hold down the on/off button

for about 2 seconds until the display

lights up. The parent unit is now switched on.

Press this button down again until the display goes off. The parent unit is now

turned off.

Channel and sub-channels:

Make sure the parent unit and the baby units are set to the same channel and

sub channel (see the illustration on page 3). Refer to the next page if the settings

need to be changed.

If the baby unit detects sound, the transmitter will be activated and the sound sent

to the parent unit.

Level of sensitivity:

Turn the dial VOXSENS located on the back of the baby unit to set the level

of sensitivity. The very left of the dial is the least sensitive, turn the dial in a

clockwise direction to increase the level of sensitivity.

Receiving volume:

You can set the call volume level on the parent unit by pressing the

or the

button; there will be confirmation beep tone. The display screen will show the

level of the selected volume (

Multiple baby units:

See page 10 if you would like to use more than one baby unit.