Directed AS-RFK2800 Manual del usuario - Página 12
Navegue en línea o descargue pdf Manual del usuario para Mando a distancia Directed AS-RFK2800. Directed AS-RFK2800 13 páginas. Two-way lcd remote system
Imprimir página
Remote Learning
Press the
button, 3 LED flashes and beeps indicates the remote is ready to program to the
system.
Per the instruction in the "Remote Pairing" section of this guide, following step 4. Press and hold
the
button, there will be no confirmation of pairing completed for this remote control.
Battery Information (1-Way)
The 1-way companion remote is powered by one 3V coin cell lithium battery (PN CR-2032) that will
last approximately one year under normal use.
Battery Replacement
1.
Using a small flat narrow object, push latch down towards battery tray while gently
prying the tray outwards from both ends until released. Remove the tray from the
remote control housing.
2.
While observing the correct polarity, replace the old battery with a new one. Seat battery
flush into tray and slide back into housing until securely latched. The remote control is
now ready for use.
Battery Information (LCD)
The LCD remote control is powered by an internal rechargeable battery that can be serviced only
through an authorized Directed dealer. The information and precautions in this section can help
maximize your battery's life and usage in providing your LCD remote control with many years of
trouble free operation.
Warnings! NEVER connect the supplied AC adapter to products other than the LCD remote
control. It is a high current device designed specifically for rapid charging of the LCD battery and
may cause severe damage or explosion when connected to any other products.
Charging the battery when the temperature is below 32°F (0°C) or above 113°F (45°C) may cause
severe battery damage and/or reduce battery life. Avoid placing the remote control in areas
exposed to extreme cold or heat (direct sunlight) when charging the battery.
Low Battery
After a command is performed the LCD and 1-way companion remote controls check their battery
level and, when the level requires attention, will begin generating alerts. Once the alerts begin they
will continue to command the system for several days but should be charged at the earliest
opportunity or failure to control the system may occur.
Low Battery Alerts
After performing a command, LOWBAT and several beeps play on the LCD remote to indicate the
battery needs to be charged.
Important! To preserve power at critically low battery levels the LCD turns the pager off and stops
receiving messages from the system. It will continue to command the system until the battery can
be charged.
P.12
User Guide