Directed Xpresskit DBALL2 Manual - Página 6

Navegue en línea o descargue pdf Manual para Por cerraduras Directed Xpresskit DBALL2. Directed Xpresskit DBALL2 14 páginas. Ford5 remote start ready (rsr) installation
También para Directed Xpresskit DBALL2: Manual de instalación (12 páginas), Manual de instalación (19 páginas), Manual de instalación (18 páginas), Manual de instalación (13 páginas), Manual de instalación (14 páginas), Manual de instalación (19 páginas), Manual de instalación (16 páginas), Manual de instalación (20 páginas), Manual de instalación (15 páginas), Manual de instalación y consulta rápida (16 páginas), Manual de instalación (18 páginas), Manual de instalación (16 páginas), Manual de instalación (18 páginas), Manual de instalación (16 páginas), Manual (19 páginas)

Imprimir página

Platform: DBALL/DBALL2

Firmware: FORD5 Range Extender Ready (RXT) Installation

Module Programming

Refer to the LED Diagnostics section on page 9 for more information and for troubleshooting purposes.

Important

Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to

ensure everything is correct prior to moving onto the next step.

Note: Before connecting either the XL202 or SmartStart module to DBALL, it is important to ensure that the proper feature and

function programming is selected using XpressVIP (version 4.5 or higher). Visit www.directechs.com to download the latest

version of the application.

Warning!

To take advantage of advanced features, you must use XpressVIP 4.5 (and higher) or the Directechs Mobile app.

Flashing a module using your computer:

1. Connect the interface module to your computer using the

XKLoader2.

2. Go to www.directechs.com using Internet Explorer, and

select the Config for RXT button.

3. Follow the instructions to select your vehicle, installation

type, and configure your options.

4. Once you have configured the firmware options, click on the

FLASH button.

When the flashing operation is successful, you can proceed with the programming instructions below.

SmartStart Installation

The DBALL module must be disconnected from any power source before SmartStart can

be connected to it. Failing to do so could damage DBALL.

To ensure that the D2D communication between SmartStart and DBALL works properly, the

Gray wire must be connected to a ground source (Rev B SmartStart), and the Brown or Blue

loop must be cut (Rev A SmartStart).

Do NOT connect the 2-pin harness (on SmartStart). Power and ground will be provided by

the DBALL D2D connector.

Connect SmartStart to DBALL using the D2D port.

XL202 Installation

Connect XL202 to DBALL using the D2D port.

Connect the 10-pin, 12-pin and 14-pin harnesses to

DBALL, then wait until the LED turns ON solid red.

Press the programming button 5 times. The LED starts to flash orange.

The LED turns ON solid orange for 3 seconds, then turns OFF.

Push the PTS (Push-To-Start) button to turn Ignition OFF.

You have successfully completed the module programming sequence.

Flashing a module using your smartphone or tablet

1. Connect the interface module to your XKLoader3.

2. Launch the Directechs Mobile app on your smartphone or

tablet.

3. Select FLASH YOUR MODULE and follow the on screen

instructions.

Rev.: 20160317

SmartStart

XL202

Press x5

Flashes

Solid x3 sec.

ENGINE

PUSH 1X

START

STOP

Page 6

Solid

Off