Clarke 3120193 Instrucciones de uso y mantenimiento - Página 7

Navegue en línea o descargue pdf Instrucciones de uso y mantenimiento para Sander Clarke 3120193. Clarke 3120193 17 páginas. Multi-sander kit

COMPRESSED AIR REQUIREMENTS

WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU

ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR

COMPRESSORS AND COMPRESSED AIR SUPPLIES.

• Use only clean, dry, regulated compressed air as a power source.

• Air compressors used to drive this tool must comply with the

appropriate European Community Safety Directives.

• A build-up of moisture or oil in the air compressor will accelerate

wear and corrosion in the tool. Ensure any moisture is drained from

the compressor daily and the inlet filter is kept clean.

• If an unusually long air hose is required, (over 8 metres), the line

pressure or the hose inside diameter may need to be increased.

• The air hose must be rated at least 150% of the maximum operating

pressure of the tool.

• A typical air line layout is shown above. If an automatic in-line filter/

regulator is used, it will keep the tool in good condition, but should

be regularly checked and topped up with oil. SAE 10 oil should be

used and the lubricator adjusted to approx 2 drops per minute.

• Never exceed the maximum operating pressure for the tool. It is

recommended that air pressure does not exceed 90 psi when

running. Higher pressures and contaminated air will shorten the life of

the tool due to faster wear and is a possible safety hazard.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]