Aleko AC 1500 Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Abrepuertas Aleko AC 1500. Aleko AC 1500 16 páginas. Sliding

Installation of Magnets for Limit Switches

Before install limit switch, make sure the

gate opener is put in manual operation. (the

clutch

connected

with

gear

shaft

disengaged) and the mains power supply is

disconnected.

Position the two Magnet Components

approximately on the gate and move the

gate by hand to fix them in place.

Fit magnets bracket

Push the gate fully closed by hand. Locate

and install the magnet bracket so that the

opener will stop at the desired close position

when the close limit switch approaches it.

Push the gate fully open by hand. Locate

and install the magnet bracket so that the

opener will stop at the desired open position

when the open limit switch approaches it.

The magnet component with N pole outside must be installed at left side and the

magnet component with S pole outside must be installed at right side from the view

inside of property.

Finally adjust the magnet to the proper position by moving the gate with the motor. The magnet should be

less than 1"away from the magnetic limit switch. If it is too far away, the switch will fail to work. The distance

between the magnet and the opener should be 0.39"- 0.59" with the opener cover on. Adjust the position of

the magnet until the positions of the opening and closing meet the requirement.