Clarke Woodworker CBS1-5B Manual de instrucciones de uso y mantenimiento - Página 5
Navegue en línea o descargue pdf Manual de instrucciones de uso y mantenimiento para Sander Clarke Woodworker CBS1-5B. Clarke Woodworker CBS1-5B 16 páginas. Belt/disc sander
Imprimir página
ELECTRICAL CONNECTIONS
WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS FULLY
BEFORE CONNECTING TO THE MAINS SUPPLY.
Before switching the product on, make sure that the voltage of your electricity
supply is the same as that indicated on the rating plate. This product is
designed to operate on 230VAC 50Hz. Connecting it to any other power
source may cause damage
This product is provided with a standard 13 amp, 230 volt (50Hz), BS 1363 plug,
for connection to a standard, domestic electrical supply. Should the plug
need changing, make sure that a plug of identical specification is used.
WARNING: THE WIRES IN THE CABLE ARE COLOURED AS FOLLOWS:
BLUE = NEUTRAL
If the colours of the wires in the power cable do not correspond with the
markings on the terminals of your plug, proceed as follows.
• Connect the blue wire
to the terminal which
is marked N.
• Connect the brown
wire to the terminal
which is marked L.
• Connect the yellow
and green wire to the
terminal which is
marked E or
WE STRONGLY RECOMMEND THAT THIS MACHINE IS CONNECTED TO THE MAINS
SUPPLY VIA AN APPROVED RESIDUAL CURRENT DEVICE (RCD) WHICH HAS A
TRIPPING CURRENT OF LESS THAN 30mA.
If you are not sure, consult a qualified electrician. DO NOT try to do any
repairs.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
.
BROWN = LIVE
Plug must be BS1363/A approved.
Earth
(Green and
Yellow)
Neutral
(Blue)
.
5
YELLOW AND GREEN = EARTH
make sure that that the outer sheath of
the cable is firmly held by the clamp
Always fit
a 5 Amp
fuse.
Live
(Brown)