Clarke 7230582 Manual de instrucciones de uso y mantenimiento - Página 7
Navegue en línea o descargue pdf Manual de instrucciones de uso y mantenimiento para Bomba de agua Clarke 7230582. Clarke 7230582 13 páginas. Submersible water pump
Imprimir página
MAINTENANCE
WARNING: BEFORE CHECKING THE CONDITION OF THE PUMP, ENSURE IT
IS UNPLUGGED FROM THE MAINS SUPPLY. IF THE UNIT IS HARD WIRED,
ENSURE THE CIRCUIT BREAKER IS OPEN.
These pumps should require no maintenance other than regular cleaning.
If the pump starts to show signs of wear or damage, contact your CLARKE
dealer for advice.
• Do not use the pump if there is any damage to the mains supply
cable or to the float switch or its cable.
• Do not attempt to repair the pump yourself, as you may damage
the waterproof seal and invalidate your guarantee. Repairs must be
carried out by your CLARKE dealer or contact the CLARKE Service
Department on 020 8988 7400.
• If the troubleshooting on page 8 does not solve your problem,
please contact the Clarke service department.
CLEANING
1. Check the pump installation regularly to ensure the base inlet is clear of
leaves or other debris.
• These pumps have screwless fittings at
their base, allowing the removal of the
plastic cover by prising the two
release clips apart in the direction of
the arrows.
• This allows better access to the cavity
at the bottom, should the pump
become badly clogged. Flush the
cavity and the impeller housing with
clean water.
• To replace the cover, ensure the
release clips line up with the holes on the base of the pump and
press the cover home.
NOTE: Do not attempt to strip the pump further as this will invalidate the
guarantee.
7