Alemite 7818-F5 Manual de servicio - Página 11
Navegue en línea o descargue pdf Manual de servicio para Bomba de agua Alemite 7818-F5. Alemite 7818-F5 16 páginas. Pump hoist and power ram
Imprimir páginaPump Hoist and Power Ram
16. Check to ensure the position of each of the three (3)
hoist's valve handles is as shown in Figure 4.
17. Attach an air line to the inlet of the hoist.
18. Set the air pressure regulator to 100 psi (6.9 Bars).
19. Place the Hoist's Valve Handle in the Up position.
• See Figure 4.
Allow the hoist to rise to a height that provides access
to the bottom of the Follower Plate.
WARNING
Position a stable support underneath the
Follower Plate.
Personal injury can occur.
20. Thread Nuts (84) onto Screws (75).
• Tighten the Nuts securely in an alternate pattern.
21. Remove the support and lower the Follower Plate onto
the Base of the hoist.
• Place the Hoist's Valve Handle in the Down
position.
22. Thread top Nut (1) on Rod (2) until it contacts
Bridge (5).
• Repeat the process for the bottom Nut.
23. Tighten each Nut alternately and evenly until secure.
Hose Attachment
Pump Motor
24. Screw Hose (59) [with thread sealant] to the inlet of
the pump's motor.
• Tighten the Hose securely.
25. Screw the opposite end of the Hose to Union (46).
• Tighten the Union securely.
Follower Plate
26. Screw Hose (71) [with thread sealant] into Follower
Plate (78).
• Tighten the Hose securely.
27. Screw the opposite end of the Hose to Valve (43).
• Tighten the Hose securely.
Alemite Corporation
1-800-548-1191-http://[email protected]
Figure 4 Control Box Valves
Operation
IMPORTANT: Hoist operation may vary.
Please read the following procedures care-
fully.
WARNING
Never point a control valve at any portion
of your body or another person. Lubricant dis-
charged at high velocity can penetrate the skin and
cause severe injury. Should product appear to
puncture the skin, get medical care immediately.
Ensure all components are in operable condition.
Replace any suspect parts prior to operation.
Personal injury can occur.
Getting Started
1. Attach a material hose (with control valve) to the
outlet of the pump.
2. Lubricate both wipers on the follower plate with the
material to be pumped.
11
SER 7818-F5
Revision (6-04)