Alemite 8202 Manual de funcionamiento, instalación, mantenimiento y reparación - Página 2
Navegue en línea o descargue pdf Manual de funcionamiento, instalación, mantenimiento y reparación para Bomba de agua Alemite 8202. Alemite 8202 10 páginas. 1/2" plastic pump
Imprimir páginability of the purchaser to retain this manual for
reference. Failure to comply with the recommen-
dations stated in this manual will damage the
pump, and void factory warranty.
leakage. Follow recommended torques stated in
this manual.
may be pressurized and must be bled of its
pressure.
pumping a product which is hazardous or toxic,
the air exhaust must be piped to an appropriate
area for safe disposition.
Page 2
Important Safety Information
IMPORTANT
Read these safety warnings
and
instructions
in
this
manual completely, before
installation and start-up of
the pump. It is the responsi-
C A U T I O N
Before
pump
operation,
inspect all gasketed fasten-
ers for looseness caused by
gasket
creep.
Re-torque
loose fasteners to prevent
W A R N I N G
Before maintenance or repair,
shut off the com-pressed air
line, bleed the pressure, and
disconnect the air line from
the pump. The discharge line
W A R N I N G
In the event of diaphragm
rupture, pumped material
may enter the air end of the
pump, and be discharged
into
the
atmosphere.
W A R N I N G
DANGER: not for use with
fluids that have a flash point
below
100°F
(38°C).
Examples: gasoline; alcohol.
Sparking could result in an
explosion which could result
in death.
all of the correct bolting is reinstalled during
assembly.
other openings and connections. Be certain the
air supply is locked out or made non-opera-
tional, so that it cannot be started while work is
being done on the pump. Be certain that
approved eye protection and protective clothing
are worn all times in the vicinity of the pump.
Failure to follow these recommendations may
result in serious injury or death.
If
miscellaneous equipment can result in fire or
explosion. A green grounding lug is provided on
the pump.
W A R N I N G
This pump is pressurized
internally with air pressure
during operation. Always
make certain that all bolting
is in good condition and that
W A R N I N G
When used for toxic or
aggressive fluids, the pump
should always be flushed
clean prior to disassembly.
W A R N I N G
Before doing any mainte-
nance on the pump, be cer-
tain all pressure is completely
vented from the pump, suc-
tion, discharge, piping, and all
W A R N I N G
Airborne particles and loud
noise hazards.
Wear ear and eye protection.
W A R N I N G
In the presence of explosive
vapors, take action to pre-
vent static sparking. Failure
to ground the pump, piping,
valves, containers, or other