Clarke 7260040 Manual - Página 3

Navegue en línea o descargue pdf Manual para Bomba de agua Clarke 7260040. Clarke 7260040 4 páginas. Submersible transfer pump
También para Clarke 7260040: Manual (2 páginas)

Imprimir página
Clarke 7260040 Manual
1.
Always check to ensure the pump is in perfect working order:
- has no apparent damage
- the filter is in place and perfectly clean
- the power cable is in perfect condition
2.
Attach the flexible hose to the outlet, securing with the jubilee clip supplied.
3.
If required, attach the stainless steel tube to the discharge end of the flexible hose,
securing with the jubilee clip supplied.
4.
Carefully lower the pump into the pit or sump etc., to be drained.
IMPORTANT, if the bottom of the pit or sump is muddy or sandy, support the pump on a
brick or something similar. DO NOT allow it to rest in the mud or sand.
5.
Connect the clamps to the 12Volt battery and the pump will operate.
IMPORTANT: ALWAYS connect the red - positive clamp to the red positive terminal of the
battery FIRST, then connect the black clamp to the black - negative terminal, ensuring both
clamps are perfectly secure.
When disconnecting - ALWAYS disconnect the black - negative clamp FIRST.
Always observe the pump discharge. Should it deteriorate during use, it is probable that the
filter is becoming blocked. In this case, disconnect the pump from the battery - black terminal
first, then carefully withdraw the pump from the pit or sump etc. DO NOT yank the cable.
Unscrew the base cap and remove the filter. Either clean thoroughly or replace as necessary,
then check the impeller to ensure it is free to rotate and is not blocked.
When satisfied, replace pump in sump or pit etc., and proceed to pump once more.
When finished, ALWAYS remove the filter and clean it thoroughly, then allow it to dry.
Thoroughly clean the pump with clean water and ensure the impeller is completely free
to rotate and is free of any contaminants.
Reassemble the pump and store in a clean, dry environment.
The following parts are available from your Clarke dealer:
1.
End Cap
2.
Filter
3.
Cable Clamp - Red
4.
Cable Clamp - Black
5.
Flexible Hose - 4M
For Spare Parts and Service, please contact your nearest dealer,
or CLARKE International, on one of the following numbers.
Method of Operation
Parts and Service
PARTS & SERVICE TEL: 020 8988 7400
PARTS & SERVICE FAX: 020 8558 3622
or
e-mail as follows:
SERVICE:
Part No:
MSP1201
MSP1202
MSP1203
MSP1204
MSP1205