Directed Electronics K10 Manual de instalación - Página 7
Navegue en línea o descargue pdf Manual de instalación para Alarma de coche Directed Electronics K10. Directed Electronics K10 16 páginas. Directed electronics, inc. installation guide
Imprimir página
door lock harness (H4), wire connection guide
___
Green
H2/A
___
Empty
H2/B
___
Blue
H2/C
I I m m p p o o r r t t a a n n t t ! ! The door lock outputs are low current and should not be attached directly to any
high current device; they are only to be used to activate relays
peripheral plug-in harnesses
LED, 2-pin WHITE plug
The LED operates at (+) 2 volt DC and plugs into the two-pin WHITE port. Make sure the LED wires are
not shorted to ground as the LED will be damaged. Multiple LED's can be used, but they must be wired
in series. The LED fits into a 9/32-inch mounting hole. Be sure to check for clearance prior to drilling
the mounting hole.
N N O O T T E E : : Never use a BLUE LED in combination with a RED LED.
override switch, 2-pin BLUE plug
The override switch should be accessible from the driver's seat. It plugs into the BLUE port on the side
of the unit. Consider how the button will be used before choosing a mounting location. Check for rear
clearance before drilling a 9/32-inch hole and mounting the button.
8
(-) Lock, (+) Unlock Output
Unless Using Resistor Interface
(-) Unlock, (+) Lock Output