Directed Electronics AS-1271 Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Arranque a distancia Directed Electronics AS-1271. Directed Electronics AS-1271 12 páginas.

Using the Remote Control

Your Remote Car Starter is equipped with a 2-button multi-channel remote control that can be

configured into 2 different functions.

Default remote function:

•

button: STOP;

•

button: START;

•

buttons (together): TRUNK release.

Alternate programmable remote function:

•

button: LOCK/UNLOCK;

•

button: START/STOP;

•

button (together): TRUNK release.

Vehicle Presets

Heater

When leaving the vehicle it is recommended to preset the accessory controls in preparation for the

next remote start. Settings for the blower motor (fan), front and rear, should not be left on HIGH. It

is recommended to leave the settings on LOW or MEDIUM instead.

Windshield Wipers, Radio & Headlights

Certain vehicles require the radio and / or windshield wipers and / or headlights circuits to become

energized while running under remote start. When leaving the vehicle you must ensure that the

windshield wipers and headlights switches are OFF. Leaving the headlights switch ON on certain

types of vehicles could cause them to remain ON even after remote starter shutdown, resulting in a

dead battery.

RemoteStarting Your Vehicle

Setting Your Vehicle into Ready Mode

If your vehicle has a manual transmission you must read the following indications. The unit must

first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready

Mode, it cannot remote start the vehicle.

Please note that Ready Mode can be enabled by the remote or the handbrake, depending on the

option that was selected by your installer. Therefore, you must follow the appropriate procedure

between the two described below in order to set your vehicle into Ready Mode.

Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.

The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is

pressed, if the parking brake is disengaged or if the ignition key is turned to the IGNITION ON

(RUN) position.

P.4

User Guide