CTEK 1046 Manual del usuario - Página 5
Navegue en línea o descargue pdf Manual del usuario para Cargador de batería CTEK 1046. CTEK 1046 8 páginas. Professional switch mode battery charger
Imprimir páginaERROR LAMP
If the error lamp is lit, check the following:
1. Is the chargers positive lead connected to the batterys
positive pole?
2. Is the charger connected to a 12V battery?
3. has charging been interrupted in STEP 1, 2 or 5?
Restart the charger by pressing the MODE-button. If charging is still
being interrupted, the battery...
STEP 1: ...is seriosly sulphated and may need to be replaced.
STEP 2: ...can not accept charge and may need to be replaced.
STEP 5: ...can not keep charge and may need to be replaced.
POWER LAMP
If the power lamp is lit with a:
1. STEAdY LIGhT:
The mains cable is connected to the wall socket.
2. fLAShING LIGhT:
The charger has entered the energy save mode. This happens if the
charger isn´t connected to the battery in 2 minutes.
TEMPERATURE SENSOR
The charger is equipped with a temperature sensor. The temperature sensor
will adjust the voltage to the ambient temperature. For MXS 10 EC - the
temperature sensor is not detachable. Activated temperature sensor will be
indicated by a lit temperature sensor indicator lamp.
REAdY TO USE
The table shows the estimated time for empty battery to 80% charge
BATTERY SIZE (Ah)
20Ah
50Ah
100Ah
200Ah
TIME TO 80% ChARGEd
2h
5h
10h
20h
TEChNICAL SPECIfICATIONS
Model number
1046
Rated Voltage AC
220–240VAC, 50–60Hz
Charging voltage
14.4V,
AGM
Start voltage
2.0V
Charging current
10A max
Current, mains
1.4A
(at full charging current)
rms
Back current drain*
Less than 1Ah/month
Ripple**
Less than 4%
Ambient
-20°C to +50°C, output power is reduced
temperature
automatically at high temperatures
8-step, fully automatic charging cycle
Charger type
Battery types
All types of 12V lead-acid batteries
(WET, MF, Ca/Ca, AGM and GEL)
Battery capacity
20–300Ah
IP65
Insulation class
*) Back current drain is the current that drains the battery if the charger is not connected
to the mains. CTEK chargers has a very low back current.
**) The quality of the charging voltage and charging current is very important. A high
current ripple heats up the battery which has an aging effect on the positive electrode.
High voltage ripple could harm other equipment that is connected to the battery. CTEK
battery chargers produce very clean voltage and current with low ripple.
14.7V,
15.8V,
13.6V
RECOND
SUPPLY
EN • 7