Directed Electronics Xpresskit CANMAX400 Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Arranque a distancia Directed Electronics Xpresskit CANMAX400. Directed Electronics Xpresskit CANMAX400 12 páginas. Standalone

Imprimir página
User guide
CANMAX400 Standalone
Out of range notification
If a command is issued from the remote, but the remote is beyond the range of the vehicle to receive the command, the
rem
ote will respond with an Out of Range notification. If this occurs, the remote will Blink rapidly the transmit indicato
turn
on the F indicator and play the error tone.
Sin
ce conditions will vary in different areas (i.e.: Weather, RF interference, etc) range may be affected and require you
be c
loser to the vehicle for successful transmission.

System maintenance

The system requires n
o sp
batteries
th
at will last app
roximately one year under normal use. The 2-way remote uses two CR2016 cell batteries and
the 1
-w
ay r
emote uses one CR2032 cell battery. When the battery begins to wea

Low battery indicator

When the batteries are low on the 2-way re
emit an additional chirp to let y
remote res
ponds the same, but without the LED flash.
The Arm/Disarm chirp
s should be programmed ON for the alarm to emit any additional
your authorized dealer if
you have any questions.

Battery replacement

Slide the door up to e
xpose the battery beneath the holder. Remove the expired battery. Place the new battery into
remote control. When p
ower is returned the remote control is ready for use.
Remote control prog
The 2-way
remote
control has me
contro
l m
od
ule onboard s
hock se sor, and for configuring the remote control user features.
To program the remote u
ser features:
1. Press and hold the
2. The remote emits one lon beep, and th
3. Press and hold the
The remote beeps two-tim
Configuration menu.
The Arm, Disarm, Remote Sta
configuration. When the LED is ON, the feature is ON.
© 2009 Directed Electronics, Inc. All rights reserved.
ecific mai
ntenance. Your re
mote it will emit two groups of beeps,
ou know it's time to change the battery.
ramming
nus for programming the remote to the system con
n
button for 12 seconds: (at 3 seconds ignore the Car number indicator.)
g
e Transmit LED turns on. This indicates the Main menu.
butt
on for 1.5 seconds:
es, and the
Transmit LED blinks two-times and stays on. You are now in the Remote
rt & Aux LEDs will turn ON, and/or blink to indicate the current remote feature
motes are powered by small coin cell lightweight 3-volt lithium
W en the battery is low on the 1-way remote, the
h
Revision: 16-Nov-09
ken, the operating range will be reduced.
the
LED will flash, and the alarm will
chirps during disarming. Ask
trol module including adjusting the
r,
to
the
7