CTEK D250S Dual Manual del usuario - Página 4
Navegue en línea o descargue pdf Manual del usuario para Accesorios para automóviles CTEK D250S Dual. CTEK D250S Dual 8 páginas. Dc/dc ic recorder
También para CTEK D250S Dual: Manual del usuario (15 páginas), Manual de instrucciones (13 páginas), Manual del usuario (12 páginas)
Imprimir página
CONNECTINg ThE ChARgER
1. Identify the supply cords and connect the positive power cord to screw terminal marked with IN +
2. Identify the target battery cords and connect the positive power cord to screw terminal marked
with OUT +
3. Connect the negative power cords from supply and target battery to screw terminal marked with
IN - and OUT -.
4. Attach the temperature sensor to the target battery.
Note: Power screws should be fastened with torque 6–8Nm, see picture 2. Exceeding this recom-
mendation may severely damage the charger. Reverse polarity will damage the charger.
Cord should be minimum
6mm² and maximum 1.0m long
Picture 2
BATTERY TYPES AND SETTINgS
D250S is intended for 12V WET, MF, AGM and most GEL lead-acid batteries. Please consult the
battery manufacturer when in doubt.
TEMPERATURE COMPENSATION
D250S has a temperature sensor cable. The units will automatically adjust the charging voltage if
the temperature deviates from +25°C. A high temperature lowers the voltage and cold conditions
is handled by higher voltage. The temperature should be measured close to the battery, therefore
attach the sensor to the battery.
4
Correct torque 6–8Nm
Ring terminals eyelets
should be M8